Maxon WL7 Especificações descarregar pdf (Página 10)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PATENTS PENDING

NOTE: The Lift Controller counts the number of cycles & lifts over the lifetime of the Lift. One

CYCLE is counted each time the Lift is unfolded from the stowed position to floor

level, lowered to the ground, raised to floor level, and then stowed. One LIFT is

counted each time the Lift is lowered from floor level to the ground, and raised back to

floor level. Read the LIFTS and CYCLES counts from the Lift Controller display

window periodically so you know when to do the maintenance checks listed below.

MAINTENANCE SCHEDULE

EVERY 500 LIFTS

NOTE: To confirm compliance with Federal Motor Vehicle Safety Standard 403, refer to

the COMPLETED LIFT INSTALLATION CHECKLIST in the Installation Manual

MP-04-01.

Check that all Decals are in place, undamaged, and legible (see DECALS pages).

Visually check the Lift for bent, broken, or worn out parts, and broken welds.

Check the electrical wiring for worn insulation, and the terminals for corrosion

and secure fit. Apply dielectric grease to connections if needed.

Replace both latch Solenoids P/N 266955-01 (see ELECTRICAL COMPONENTS,

Item 23).

Check for loose fasteners (nuts, bolts, screws & rivets). Also, check cotter pins, clevis

pins, retaining ring pins & retaining rings for noticeable wear and damage.

Check that all anti-slip and safety striping is in place and undamaged (see ANTI-SLIP &

SAFETY STRIPING pages).

EVERY 2500 CYCLES

Check the Inboard Rollstop Actuator Assembly wiring connections, routing, and condition

from Actuator to Controller. Repair if needed (see PLATFORM CLOSER, Item 4 &

ELECTRICAL SYSTEM DIAGRAM).

EVERY 3000 LIFTS

Check the large bearing on slider-end of Actuator. If bearing looks worn at first inspection,

remove and reinstall bearing with the ends reversed. Replace bearing P/N 266545-03

(see PLATFORM CLOSER, Item 14), if follow-on inspections reveal more wear.

EVERY 5000 LIFTS

Replace both Platform light bulbs P/N 906475-01 (see ELECTRICAL COMPONENTS,

Item 8A).

Check both Hydraulic Cylinders for leaks. If a film of hydraulic fluid is visible on cylinder

seals Lift can still be operated. However, if fluid is dripping from the cylinders, replace

them (see HYDRAULIC COMPONENTS, Item 13).

EVERY 10000 LIFTS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 60 61

Sem comentários

Maxon WL7 Especificações Página 10