Maxon WL7-vers. C Manual do Operador descarregar pdf (Página 28)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

1. Use template (FIG. 27-1) or the base plate on the

Lift (FIG. 28-1, holes 1-10) to mark eight (8) to ten

(10) 7/16” mounting holes through the vehicle ﬂ oor.

Before drilling holes in the vehicle ﬂ oor, make sure

no wires and ﬂ uid lines are too close to hole loca-

tions. Drill holes 1, 2, 9, 3, and 4.

BASE PLATE BOLT

HOLE PATTERN

FIG. 28-1

BACK

FRONT

MOUNTING THE LIFT

NOTE: MAXON recommends using all 10 carriage screws (Kit items) to bolt Lift to

vehicle. A minimum of 8 screws or bolts and use of holes 1, 2, 3, 4 & 9 are

required for correct installation. Also, the 3 front holes should be selected to

give a symmetrical bolt pattern (i.e. holes 5,10, & 8 or holes 6,10, & 7).

3. Temporarily secure Lift to vehicle with two mounting

bolts (Kit items), inserted through base plate holes

1 and 4, or holes 2 and 3 (FIG. 28-1). Use two lock

nuts and correct under-vehicle supports (Kit items) to

secure the Lift. Use instructions supplied with vehicle

installation kit to select the correct bolts, nuts and sup-

ports. Alternately, tighten the two bolts and nuts to 20

to 30 lbs.-ft.

NOTE: Vehicle ﬂ oor must meet the requirements shown at the beginning of the

VEHICLE REQUIREMENTS section in this Installation Manual.

2. Position Lift so holes 1-10 in the base plate (FIG. 28-1)

are aligned with the correct holes drilled in vehicle ﬂ oor.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 73 74

Sem comentários

Maxon WL7-vers. C Manual do Operador Página 28