Maxon WL7-vers. C Manual do Operador descarregar pdf (Página 39)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

CHECKING HYDRAULIC FLUID LEVEL

CAUTION

Keep dirt, water and other contaminants from entering the hydraulic sys-

tem. Before opening the hydraulic ﬂ uid reservoir ﬁ ller cap, drain plug and

hydraulic lines, wipe off contaminants that can get in the openings. Also,

protect the openings from accidental contamination.

3. Unbolt the pump cover as

shown in FIG. 39-1. Observe

the ﬂ uid level at the decal on

pump reservoir. Fluid level

should be in the MIN-MAX

range shown on decal (FIG.

39-2)

1. Check the hydraulic ﬂ uid

level in reservoir as follows.

HYDRAULIC FLUID LEVEL

(LH PUMP SHOWN)

FIG. 39-2

UNBOLTING/BOLTING PUMP COVER

(LH PUMP SHOWN)

FIG. 39-1

SCREWS

PUMP COVER

4. Pull out ﬁ ller cap (FIG. 39-2). Fill the

reservoir with hydraulic ﬂ uid (TABLE

39-1) to level shown in FIG. 39-2. Re-

install ﬁ ller cap (FIG. 39-2).

5. Bolt on the pump cover as shown

in FIG. 39-1. Tighten the 5/16”-18

cover screws until snug.

TABLE 39-1

RECOMMENDED HYDRAULIC FLUID

BRAND PART NUMBER

ROSEMEAD THS FLUID 17111

EXXON UNIVIS HVI 26

NOTE: If the expected seasonal

temperatures are below

20°F, use MIL-H-5606G

hydraulic ﬂ uid.

RESERVOIR

FILLER CAP

2. Raise and stow platform.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 73 74

Comentários a estes Manuais

Sem comentários

Maxon WL7-vers. C Manual do Operador Página 39

Comentários a estes Manuais